My auto level does not level the RL36 . The front drivers side is always low. It does not sag or leak. No air locks. Can't seem to get the base line of level correct. Any advice.

I think I found the Q & A manual from LCI that covers the problem. Thanks for the link and info.

I found that the auto leverler sensor in the front underbelly has come loose and was hanging down. Reinstalling it corrected some of the problem, it still is about 1 to 2 degrees off and I use a 3' level on the kitchen floor and do it manually.

The auto level has a memory that can be calibrated. Use a 4' level on the floor and manually level the trailer. Shut the level up key pad off. Push the down arrow 10 times then the up arrow 10 times. The display will turn on and recalibrate itself.I have only had to do this once to mine