Forum

Notifications
Clear all

LCI Auto Leveling

7 Posts
1 Users
0 Reactions
1,556 Views
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

My auto level display screen has gone blank. The green back light is on, but no info. The system works otherwise. Any thoughts?

 
Posted : November 1, 2015 8:31 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Good Morning Bob ,
I am not sure this will work , but it's worth giving it a try .. Find the power to the LCI control box and disconnect it for a few minutes.. Hopefully once you reconnect the power , it will work. This has come up a few times around the forums and that was what they were told to try first.
It has not happened to me , so I can't say for sure..good luck

 
Posted : November 1, 2015 9:55 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

There is a Level Up System Manual in the Manuals Section of this forum.

 
Posted : November 1, 2015 1:16 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

My auto level display screen has gone blank. The green back light is on, but no info. The system works otherwise. Any thoughts?

Ours did that. We had to guess what it was reading, but it still functioned. We had the module replaced under warranty at the Redwood Rally this past August.

 
Posted : November 1, 2015 2:25 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Disconnecting the control module for 20 mins did work. Display is now functioning properly! THANKS!

 
Posted : November 2, 2015 9:54 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Glad it worked !!

Where did you disconnect it at ?

 
Posted : November 2, 2015 9:56 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

The control panel has a small slot on top. A small screwdriver allows you to pop it out from the retainer. Disconnected the plug on the back.

 
Posted : November 2, 2015 10:00 AM
Share: