Forum

Notifications
Clear all

MORryde IS - Installation and 1st Impressions

17 Posts
2 Users
0 Reactions
2,505 Views
KenA
 KenA
(@kena)
Posts: 665
Honorable Member
Topic starter
 

I am pulling right now and before the IS install when I would go on/off bridges or bumps some of the movement would transfer into the truck even through the trail air. Now the truck does feel a little movement from e trailer but very minimal. The recovery when going on/off bridges is very quick.

I have the Firestone bags on my truck running right now @ 60psi.

Ken & Gizzi
Ford 2015 F350 DRW
--
"My Redwood; Go anywhere and always be at home."
"The trouble with trouble is it starts as fun"

"I skate to where the puck is going to be, not where it has been" - Wayne Gretzky

 
Posted : August 16, 2015 11:00 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
 

So far, we use the "earthquake putty" available at Camping world and probably other locations. It might also go by the names of:

Stay Putty
Rock & Roll Gel/Putty
Quake Putty
Quake Hold
Museum Putty
Mystic Clay

We purchased ours at United RV in Fort Worth:

http://rvparts.unitedrv.com/search.php?q=putty&x=0&y=0

So far, so good. It does not leave a stain and everything has stayed in place. Even through the Oklahoma and Illinois HORRIBLE roads.

But still, if there is any extra cushion to be had, I would at least look into it.

Thanks for posting.

GipCTravelers

 
Posted : August 16, 2015 12:00 PM
Page 2 / 2
Share: