Just getting adjusted to our new 39MB. We have outside speakers, but I cannot figure out how to activate them on the installed Jensen Audio System. There are A,B, & C buttons on the system for speakers, but they only seem to control the inside speakers and I have no sound coming out of the outside speakers.

Any help would be greatly appreciated.

Try the fade button or dial I think it changes from in to out. Some use the a or b switch to change from inside to out

We have a 17 MB, our outside speakers come on when we activate the "B" speakers on the Jensen Audio System. Hope this helps!

Joe and I downloaded the manual from the Jensen Web site. It is a great help. I also asked them about a larger remote but they don't have one. Enjoy!

Thanks for your suggestions. I finally contacted Jensen technical support. They were very good. But, after some troubleshooting with them, it was determined that either the Jensen unit is bad or the speakers are wired incorrectly in the Redwood. I have set up a service appointment with my dealer to get the warranty work done.