Forum

Notifications
Clear all

Roofing Option

9 Posts
1 Users
0 Reactions
1,756 Views
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Here is another roofing option...

Depending on thickness (50 or 60 Mil), it can add about 175 lbs to an RV. Subtract that from the existing roof applied by Redwood, it would probably balance out a lot less. If you're brave enough, they also have an 80 Mil product.

We use this in the construction industry. I've seen it installed on schools, and commercial buildings.

The warranty is 15 to 20 years (depending).

It's highly reflective and even qualifies for LEED credits (like you need that! HA!)

It's also super reflective for heat. (No. I'm not a salesman or installer. I have used it and will strongly consider it when it comes time).

When it comes to durability, it's tough! If you have to patch it, the roof uses patches similar to a swimming pool patch. But chances are, one would not need it. IT IS SUPER TOUGH!

I've thought (like others) about the Rhino type of materials. I wondered how that might work out.

The Armor flex material sounds really good, but it also seems to be pretty expensive.

Does anyone know the Mil thickness of the roofing material Redwood is using? I know it's pretty thin and I have already experienced a few small tears. About the only thing I've found to patch it so far is a good RV roof caulk. I don't like or trust that.

http://duro-last.com/duro-last_roofing_system

As of today, I wrote to the company to see if this has been used on an RV before. Maybe I can be a test guinea pig... :sick:

 
Posted : November 16, 2015 9:28 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

At the Redwood Rally this year, the rep from ALPHA Roof Systems, briefly went over repair procedures. You use the same material that roof is done in. You apply a patch over the damage, and it is heated to adhere it to the original ALPHA roofing material. I have contact info if you would like it.

 
Posted : November 18, 2015 3:40 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

They also said that Camping World is the supplier for Alpha Roofing. That is where I picked up my Leveling caulk.

 
Posted : November 18, 2015 5:39 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Does anyone have a "spec" on the Alpha Roof? What Mil thickness is it and what is the actual material made of?

 
Posted : November 18, 2015 8:12 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

.034 inches...made of rubber and plastic. I found this info on Google "ALPHA RV Roofing".

Bob

 
Posted : November 18, 2015 8:21 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

I had sprayed on roof installed by rvroof.com. Guaranteed for life. All I have to do is wash it with mild soap and water. Recommend this roof 100%. Cost is approx $150 per linear foot.

 
Posted : November 19, 2015 2:03 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

I had sprayed on roof installed by rvroof.com. Guaranteed for life. All I have to do is wash it with mild soap and water. Recommend this roof 100%. Cost is approx $150 per linear foot.

Is that material polyurea? If so, it is also used to coat the decks of fishing boats in Alaska. Thick, tough, and bulletproof! They use it for corrosion protection and traction.

 
Posted : November 19, 2015 2:54 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

It is a flexible plastic 1/8th + inch thick. I do not know the type of plastic used

 
Posted : November 19, 2015 4:05 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Was it sprayed on or rolled? Polyurea is normally sprayed. It is also used as bedliners.

 
Posted : November 19, 2015 6:05 PM
Share: