I have the 38RL, bedroom Slide with the smaller bed Slide in it. Everything worked fine when I pulled it in this morning and when I went to put it back out a few hours later the small slide will not go out. It tries but only one side wants moves out. I have looked all over cant find anything that would be blocking it, My question is, where is all the mechanism to work that smaller slide. the slide is in and its livable for now just trying to diagnose the issue...Thanks

Mike

well after digging around and you tube, I found the controller, its behind the cover for the lippert leveling system. the lights are telling me that motor 1 has a short in the wiring. since the slide its closed does anyone know how to get to the worm drive. I have traced the wire all the way up to where it disappears into the slide wall. other than that I think I'm at a stopping point and may have to find a redwood dealer.

Here are a variety of LCi Troubleshooting Guides (Hydraulic and Schwintek) and a troubleshooting videos. I suspect a bad motor or the wiring has come lose from the motor. Anyway, these manuals and videos should get you there:

https://www.youtube.com/watch?v=xojUdPDWNS0

https://www.youtube.com/watch?v=bGL4aILZYcY

https://www.youtube.com/watch?v=DviEbWT3lUo

https://www.youtube.com/watch?v=JW9BAMjeydo

Contact Lippert Components Customer Support at 574.537.8900 or parts@lci1.com with any questions about your Schwintek In-Wall Slide-Out System.