This fell out from beneath my living room slide under where the refer sits. I know it's to help divert hoses and wires from getting caught up in the piston and gears that are under there but I can't figure out where it was bolted or welded at. Thanks
It's a 2017 Redwood 38 RL
Michael a Stark
Here are 3 pictures...
The plate mounts onto the Hydraulic Stem Bar. They used (2) #8 screws to hold it on. It's the reason a lot of your trim falls off too. Use larger self-taping screws. The larger the better. Add a couple of extras. Check your fender skirts as well. They did the same thing there and my bet is that you're probably missing a bunch of those screws as well. I added at least 1 more to each holding bracket.
Here are the fender skirts:
Thank you. I just check and it was held on with one screw that broke off. I'll fix that.
And yes, only one screw top and bottom on each skirt bracket.
Mike