Forum

Notifications
Clear all

Onan Generator

5 Posts
1 Users
0 Reactions
1,211 Views
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Can anyone tell me how to reset the flashing "change oil" indicator in the hour meter located in the cabinet inside the rv. It is an ENM meter, I can't seam to find any info on how to do this. Any help would be appreciated.

 
Posted : February 25, 2017 11:46 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Not sure that this is the exact answer but might be worth a shot. It comes from the Onan RV Generator Handbook:

"Restoring Fault Code Blinking – The fault code stops blinking after five minutes (15 minutes, Series HGJAA). Press Stop three times within five seconds to restore blinking. Note that the last fault logged will blink, even after the condition that caused the shutdown has been corrected."

Here it the link:

http://power.cummins.com/sites/default/files/literature/rv/F-1123-EN.pdf

Here is the Onan Generator Accessories link in case you accessories:

http://power.cummins.com/sites/default/files/literature/brochures/f-832.pdf

Service Diagram:

https://powersuite.cummins.com/PS5/PS5Content/SiteContent/en/Binary_Asset/pdf/Consumer/diagram/spd_mq4.pdf

 
Posted : February 25, 2017 7:07 PM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Thanks for the information. I called an onan service tech, very nice guy we spent about 45 min. On the phone. He determined the meter is not onan it's something Redwood installed and he has no idea how to reset it. I thought maybe all Redwoods were set up this way. That's why I came here.

 
Posted : February 26, 2017 4:51 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Try contacting Redwood on this forum. Send them an IM. They are pretty good at getting back to you.

I think this link will take you right there, but if it doesn't, look them up in the Members List on page 14 (Mid way down).

http://www.redwoodrvowners-dev.com/index.php?option=com_uddeim&task=new&recip=754&Itemid=221

 
Posted : February 26, 2017 9:50 AM
Jim
 Jim
(@j_a_wolfe)
Posts: 10846
Member
Topic starter
 

Thanks I'll try that.

 
Posted : February 26, 2017 7:43 PM
Share: